Peavey KB/A 15 - Technical Specifications; Performance and Electrical Specifications; Input;Output and Physical Dimensions

SPECIFICATIONS
RATED POWER & LOAD
15 W RMS into 3.2 ohms
POWER@CLIPPING (TYPICAL)
(5% THD, 1 kHz, 120 VAC
line)
15 W RMS into 3.2 ohms
TOTAL HARMONIC DISTORTION
Less than 0.5%, 100 mW to
10W RMS, 60 Hz to 10kHz,
3.2 ohms
(typically below 0.2%)
POWER CONSUMPTION
40 watts, 50/60 Hz, 120 VAC
PREAMP SECTION
The following specs are
measured @1 kHz with the
master EQ flat @ 0 dB.
Nominal values are with
levels @5
Minimum values are with
levels @10
INSTRUMENT INPUTS
Input impedance:
220 K ohms
Nominal input level:
-7 dBV, 450 mV RMS
Minimum input level:
-26 dBV, 50 mV RMS
Maximum input level:
+8dBV, 2.5V RMS
HEADPHONE OUTPUT
(Stereo headphone jack,
mono signal)
Load impedance:
4 ohms or greater
Nominal power output:
20 mW into 4 ohms.
(Switching jack disconnects
the internal speaker when
plug is inserted)
The following specs measured at
nominal settings, all inputs
terminated with 47K ohms.
FREQUENCY RESPONSE
+0, -2 dB, 50 Hz to 10 kHz
PREAMP HUM & NOISE
80 dBV (both channels
operating)
EQUALIZATION (both channels)
±15 dB @80Hz & 8kHz,
shelving
WEIGHT & DIMENSIONS
Weight: 15.2 lbs
Width: 14.875”
Depth: 8.5”
Height: 14.125”
ALL SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
5