Need help?Do you have a question about the Peavey PC4-X and is the answer not in the manual?
General| Frequency Range | 20 Hz to 20 kHz, +0/-0.5 dB |
|---|---|
| Input Impedance | 20 kΩ balanced, 10 kΩ unbalanced |
| Maximum Input Level | +22 dBu |
| Maximum Output Level | +22 dBu |
| Frequency Response | 20 Hz - 20 kHz, ±0.5 dB |
| THD | <0.01% @ 1 kHz |
| Crossover Slopes | 24 dB/octave |
| Subsonic Filter | 18 dB/octave |
| Power Consumption | 15 W |
| Inputs | 2 x XLR |
| Outputs | XLR |
| Dimensions | 483 x 44 mm |
Details selecting system configurations, crossover filter types, and setting frequencies using Master and Frequency keys.
Details setting low-cut, high-cut, and crossover frequencies for various configurations using the Frequency key.
Guides on setting input levels, adjusting output levels, and using LED meters for proper gain staging.
Explains setting input pre-delay and output delays for time alignment and driver synchronization.
Provides methods for setting delays using measurements and analyzers, and details output delay displays.
Guides on saving custom configurations as named presets for easy recall and system management.
Explains how to load previously saved presets to quickly recall configurations.
Warns about potential permanent hearing loss from exposure to extremely high noise levels and specifies OSHA permissible exposure limits.
Advises on preventing clipping, damage from tape adhesives, and general care to maintain unit integrity.
To Next Page
