ENABLE
GLOBAL COMPRESSOR
HIGH
MID-MORPH
LOW
0
-
+
min max
0
-
+
min max
0
-
+
min max
0
-
+
min max
0
-
+
min max
0
-
+
min max
0
-
+
min max
0
low high
-
+
0
low high
-
+
PAN
c
RL
left right
c
RL
left right
c
RL
left right
c
RL
left right
LEVEL
min max min max min max
GAIN
1
MAIN L+R
L R
DIGITAL
RETURN
CONTROL ROOM
TO MAIN
A/B TOGGLE
A
B
RL
TO CONTROL
ROOM
min max
min max min max min max
less more
min max min max
min max min max min max
EFX SELECT
EFX ADJUST
EFFECTS ADJUST
PHANTOM POWER 48V
1.Plate Reverb 1
2.Plate Reverb 2
3.Plate Reverb 3
4.Hall Reverb 1
5.Hall Reverb 2
6.Hall Reverb 3
7.Room Reverb 1
8.Room Reverb 2
9.Room Reverb 3
10.Double
11.Slapback
12.Dly Few Repaets
13.Dly More Repeats
14.Chorus 1
15.Chorus 2
16.Chorus 3
TIME
RATE
EFX MUTE
LEVEL LEVEL
HEADPHONE
6 INPUT STEREO MIXER
WITH DIGITAL EFFECTS AND BLUETOOTH
ELECTRIC GUITAR PRE-SHAPE
PV 6 BT
PV 6 BT
POWER
EQ BYPASS
HIGH
MID-MORPH
LOW
PAN
LEVEL
GAIN
2
EFX
EQ BYPASS
HIGH
LOW
MID
PAN
LEVEL
LEVEL
min max
COMPRESSOR LEVEL
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
5/6
LEVEL
BAL
1/4”
RCA
Bluetooth
R
L
MAIN OUT
DIGITAL
3
STEREO
4R
L
DIRECT OUT
1/4”-Hi-Z
DIRECT OUT
RL
5
6R
L
ON/OFF
5/6
PV®6BT Front Panel
22
23
24
25
26
27
19 20 21
28 29
11
13
14
15
16
18
17
12
11
12
13
14
15
16
17
18
19
20
21
ree-way Audio Input Selector
Allows you to select between a 1/4", RCA audio input, or Bluetooth
connection.
Balance
Adjusts relative levels of le and right channels.
Level
Adjusts the level of the source selected by (11).
EFX Mute
Depressing this button will cut all digital eects from the main mix.
EFX Adjust
is rotary encoder adjusts the parameter of the eect selected by
EFX SELECT (16). For reverbs, double, slapback, and delays, the knob
controls the time. For chorus eects, this knob controls the rate. Any
adjustment you make with this knob will be stored into memory until
the next time you adjust the parameter. In other words, your changes
will "stick" even if you select a dierent eect. When you return, things
will be the way you le them.
EFX SELECT
Use this rotary encoder to choose which eect you want to
apply. ere are 9 reverbs, 4 delays, and 3 chorus eects.
You can ne-tune the behavior of the selected eect with
the EFX ADJUST knob.
Global Compressor Enable Button
When depressed, the compressor is enabled.
LED Meters
Two six-segment LED arrays are provided to monitor the levels of the
main le/right outputs. ese meters range from -18 dBu to +19dBu.
e highest green LED corresponds to +4 dBu at the outputs.
Digital Return Level
Controls the signal level coming in to the USB digital audio port, typi-
cally from a USB-equipped computer. e nominal setting is near 12:00
for this control.
To Control Room
When depressed, USB digital audio return is routed to the control
room and headphone outputs. Use this setting when recording with
DAW soware to avoid unintended loops.
To Main
When depressed, USB digital audio return is routed to the Main sum-
ming amp. is setting is recommended only when there is a
requirement to playback through the main outputs, at which time the
DAW soware must have input monitoring disabled.
Beware of creating an unintended loop, which results in very
LOUD and uncontrolled oscillation that can damage loudspeakers
and eardrums!