Need help?Do you have a question about the Peavey SPECIAL Special 112 and is the answer not in the manual?
General| Speaker Size | 12 inch |
|---|---|
| Channels | 2 (Clean and Lead) |
| Effects | Reverb |
| Type | Solid State |
| Footswitch | Optional (for channel switching) |
| EQ | 3-band EQ |
| Power Output | 65 Watts RMS into 8 Ohms |
Alerts users to uninsulated dangerous voltage within the enclosure.
Highlights important operating and maintenance instructions in accompanying literature.
Input for most electric guitars, 6 dB louder than Low Gain input.
For high-output instruments to prevent overloading High Gain input.
Controls Normal channel volume, unaffected by SuperSat or Post Gain.
Provides a 6 dB boost to treble frequencies when activated.
Selects between Lead and Normal channels.
Passive tone controls for bass, mid, and treble frequencies.
Active tone control for extreme high frequencies, ±15 dB boost/cut.
Transistor simulation of tube distortion (soft clipping).
Shifts frequency range of the "Body" control.
Boosts overall system gain when activated.
Controls overall volume of the Lead channel.
Active tone control for low frequencies (±15 dB), not functional on Normal channel.
Active tone control for mid frequencies (±15 dB), not functional on Normal channel.
Active tone control for high frequencies (±15 dB), not functional on Normal channel.
Output for external low-level effects or signal processing equipment.
Input for returning signals from external effects or signal processors.
Controls the overall reverb level.
Indicates when AC power is supplied to the amp.
Three-position switch to minimize hum, not functional on 220/240V models.
Turns the unit on/off; activates the power LED.
Connects line-level signal to the power amplifier.
Routes amplified signal to a mixer, tape recorder, etc.
For connecting the supplied remote footswitch to select channels and reverb.
3-wire grounded power cord for safety and noise reduction.
General settings for a clean guitar tone.
General settings for a metal guitar tone.
General settings for a medium distortion guitar tone.
General settings for a country lead guitar tone.
Details power output, clipping, frequency response, and distortion.
Details input levels, effects send/return, EQ, and voicing specs.
Illustrates the signal path within the amplifier unit.
Details the one-year limited warranty and 90-day warranty on tubes/meters.
Instructions for completing the warranty card and obtaining service.
Lists 18 essential safety and operating instructions for the product.
Warns about potential hearing loss from high noise levels and specifies OSHA limits.
To Next Page