Need help?Do you have a question about the Peavey Special and is the answer not in the manual?
General| Reverb | Yes |
|---|---|
| Channels | 2 |
| Equalizer | 3-band |
| Controls | Reverb |
| Type | Solid-state |
| Power Output | 130 watts |
Details input jacks, the Gain Block™ front end, Pre Gain, and Saturation™ controls.
Explains Post Gain, Normal Gain, AUTOMIX™ circuitry, and settings for clean/distortion.
Describes the low EQ control for shaping bass frequencies and its impact on amplifier performance.
Details Mid EQ, High EQ/Pull Thick, Presence EQ, and Master Reverb controls for tonal shaping.
Covers On/Off switch, Pilot LED, and Ground Lift switch for amplifier operation and safety.
Specifies that the normal channel can only be activated using the remote AUTOMIX™ footswitch.
Details the stereo jack for remote control and notes proper footswitch insertion for functionality.
Explains Preamp Out/Power Amp In jacks for patching and the importance of the grounded line cord.
Covers speaker jack usage, impedance, and internal fuse safety precautions.
Lists detailed technical specifications for power amplifier, preamp, and equalization sections.
To Next Page