Need help?Do you have a question about the Peavey StudioPro 112 and is the answer not in the manual?
General| Effects | Reverb |
|---|---|
| Power Output | 65 Watts RMS |
| Output Power | 65 watts |
| Speaker Size | 12 inches |
| Channels | 2 |
| Inputs | Instrument |
| Outputs | 1 x Headphone |
| Controls | Reverb |
Input for most electric guitars, 6 dB louder than Low Gain.
For instruments with extremely high outputs, doubles as Low Gain if both inputs used.
Controls normal channel volume, unaffected by SuperSat® or Post Gain.
Provides a +6 dB boost to treble frequencies when activated.
Selects lead or normal channel. Remote footswitch also controls selection.
Passive tone controls for low, mid, and high frequencies.
Simulates tube distortion (soft clipping); requires lead channel activation.
Controls overall lead channel volume; adjust after desired sound is achieved.
Active tone control for low frequencies (+/-15 dB), functional on lead channel.
Active tone control for high frequencies (+/-15 dB), functional on lead channel.
Output for signals to external low-level effects or signal processing equipment.
Input for signals from external low-level effects or signal processing equipment.
Controls the overall reverb level.
Illuminates when AC power is supplied to the amplifier.
Turns the unit on/off. Red pilot light illuminates when power is supplied.
3-wire line cable with grounding facilities for safety. Do not remove ground pin.
Stereo jack for headset; automatically turns off internal speaker when connected.
Routes amplified signal to mixers, tape recorders, etc. Does not affect amp operation.
For optional footswitch to select channels and defeat reverb. Insert plug fully.
Details rated power and load, including clipping characteristics and frequency response.
Specs for input levels, impedance, and effects send/return for preamp stages.
Specifies nominal power output for headphones.
Measures noise levels relative to nominal input level.
Describes equalization characteristics for the Normal Channel.
Details voicing controls for the Lead Channel.
Explains functions of the remote footswitch for channel and reverb control.
Diagram showing signal flow and explanation of unit functions.
Covers defects in material/workmanship for one year for original retail purchaser.
Specific warranty for tubes and meters for ninety days from date of purchase.
Details terms that void warranties and limitations on remedies.
Outlines Peavey's liability limitations, disclaimers, and warranty terms.
Instructions for completing and mailing the warranty registration card.
Warns about permanent hearing loss from high noise levels and provides OSHA exposure limits.
Provides general cautions for safe operation, ventilation, heat, water proximity, and maintenance.
To Next Page