Need help?Do you have a question about the Peavey Standard and is the answer not in the manual?
Sets the input preamplifier gain, controlling sensitivity, not amplifier power output.
Features High, Low, and Middle controls for passive tone shaping, duplicating British amp characteristics.
Functions identically to the normal channel gain control for consistent performance.
Advanced negative feedback tone networks with cut/boost for frequency bands, offering versatile tonal shaping.
Connects the instrument signal exclusively to the effects channel.
Automatically routes the instrument signal to both normal and effects channels for blended sounds.
Directs the instrument signal solely into the normal channel.
Chains the normal channel output into the effects channel input for increased sustain and harmonics.
Provides a low-level signal output for driving additional booster power amplifiers.
Designed for a 4-ohm total load; using lower impedances risks overloading the power amplifier.
Master control for reverb level, remotely switchable via footswitch.
Applies nonlinear feedback for natural distortion, remotely controlled by footswitch.
Explains the Selector, Combiner, Distortion, and Reverb buttons for remote control.
Illustrates parallel and series mode operations, showing signal flow through preamp stages.
Detailed circuit diagram of the pre-amplifier section, including tone and gain stages.
Circuit diagram for the 130 Watt power amplifier stage, including power supply and output components.
To Next Page
General