Peavey Studio Pro 50

STUDIO PRO™ 50 SPECIFICATIONS
EE
Power Amplitler Section:
Rated Power & Loa
50 W RMS into 8 ohms.
Power at Clipping:
(Typically 5% THD, 1 KHZ, 120 Vac line)
36 W RMS into 16 ohms
5T W RMS into 8 ohms
45 W RMS into 4 ohms.
2 ohms not recommended
Frequency Response:
+0, -2 dB, 60 Hz to 20 KHz @ 40 W RMS into 8 ohms
Total Harmonic Distortion:
Less than 0.2%, 100 mW to 40 W RMS
60 Hz to 10 KHz, 8 ohms,
typically below 0.1%
Hum & Nol:
Greater than 90 dB below rated power
Power Consumption: (Domestic)
180 watts, 50/60 Hz, 120 Vac
Preamp Section:
The following specs ere measured @ 1 KHz with the controls.
preset as follows:
Minimum Levels are with Pre Gain @ 10
Preamp Jack "A" Input:
Impedance: High Z, 220K ohms
Nominal Input Level: -28 dBV, 40 mV RMS
Minimum Input Level: -46 dBV, 5 mV RMS
Maximum Input Level: +4 dBV, 1.5 V AMS
Preamp Jack "B" Input:
Impedance: High Z, 44K ohms
Nominal Input Level: -22 dBV, 80 mv RMS
Minimum Input Level: -40 dBV, 10 mV RMS
Maximum Input Level: +10 dBV, 3 V RMS
Preamp Output:
Load Impedance: 1K ohms or greater
Nominal Output: 0 dBV, 1V RMS
Line Output:
Load Impedance: 1K ohms or greater.
Nominal Output: -10 dBV, 300 mV RMS
Power Amp Input:
Impedance: High Z, 22K ohms.
Designed Input Level: 0 dBV, 1V RMS
System Hum & Noise @ Nominal Input Level:
(20 Hz to 20 KHz unweighted)
70 dB below rated power
Pul Bright Off (in)
Saturallon" @ 0
Post Gain @ 10
Low & High EQ @ 10
Mid EQ Qo
Pull Thick Ott (In
Reverb @ 0
Nominal Level
re with Pre Gain @ 5
Equalization:
Special low, mid & high passive EQ circuitry
Pull Bright: «6 d8 @ 2 KHz
Pull Thick: Special EQ
Footswitch Features
Reverb function defeated.
Saturation™ function defeated
Due to our efforts tor constant improvement, features and specifications are subject to change without notice:
EE
=
Come,
CI
cue cde
Tu
E
cem
x
PEAVEY ELECTRONICS CORPORATION / 711 A Street / Meridian, MS 39301 / U.S.A. / Telephone: (601) 483-5365 / Telex: 504115
#80300524 e1985
Printed in U.S.A. 1/86