Need help?Do you have a question about the Peavey CLASSIC 50 and is the answer not in the manual?
General| Power Output | 50 Watts |
|---|---|
| Preamp Tubes | 3 x 12AX7 |
| Power Tubes | 4 x EL84 |
| Channels | 2 (Normal and Lead) |
| Reverb | Yes |
| Effects Loop | Yes |
| Type | Tube Amplifier |
| Controls | Bass, Mid, Treble, Reverb |
| Outputs | Extension Speaker Jack |
| Effects | Reverb |
Device complies with FCC Part 15 and Industry Canada license-exempt RSS standards.
Operation requires no harmful interference and acceptance of received interference.
Unauthorized modifications void user authority and can cause interference.
Suggestions for correcting radio or TV reception interference.
Complies with FCC radiation exposure limits for uncontrolled environments.
Places amp in standby or active mode. Tubes remain hot in standby.
Turns the amplifier on or off.
Selects between Lead and Normal channels.
Illuminates when AC power is supplied to the amp.
Active control boosting extreme high frequencies by up to 6 dB.
Controls the overall volume level of the system.
Passive tone controls for bass, middle, and treble frequencies.
Controls echo effect; remote footswitch can control ON/OFF.
Controls overall volume level of the Lead channel.
Controls input volume level of the Lead channel.
Controls volume level of the Normal channel.
Input for enhanced high frequency response.
Input for instrument-level signals.
Receptacle for IEC line cord providing AC power.
Protects the unit; must be replaced with the same type and value.
SEND output and RETURN input for external effects.
Jacks for connecting speakers at 16 or 8 ohms.
Connects footswitch for channel select, reverb, and boost.
Details rated power, clipping, frequency response, and power consumption.
Details input levels, impedance, EQ, effects send/return, and footswitch functions.
To Next Page
