Peavey TransTube Studio Pro 112 - Page 5

SPECIFICATIONS
Rated Power & Load:
65 W RMS into 8 ohms
4 ohms not recommended
Power @ Clipping: (Typically)
(5% THD, 1 kHz, 120 VAC line)
65 W RMS into 8 ohms
Frequency Response:
+O, 3 dB, 60 Hz to 20 kHz,
@ 50 W RMS into 8 ohms
Hum & Noise:
Greater than 78 dB below rated
power
Power Consumption:
200 W @ 50/60 Hz, 120 V AC
(Domestic)
PREAMP SECTION
The following specs are measured
@ 1 kHz with the controls preset
as follows:
Push Bright, Off (Out)
Channel Select Normal (Out)
Low & High @ 10
Mid @ 0
Pre & Post Gain @ 10
Gain & Thrash, Off (Out)
Normal Levels are with normal
volume @ 5
Minimum Levels are with normal
volume @ 10
Preamp High Gain Input:
Impedance: High Z, 1 M ohm
Nominal Input Level: - 14 dBV,
200 mV RMS
Minimum Input Level: -24 dBV,
60 mV RMS
Maximum Input Level: 0 dBV,
1VRMS
Preamp Low Gain Input:
Impedance: High Z, 44 K ohms
Nominal Input Level: -8 dBV,
400 mV RMS
Minimum Input Level: - 18 dBV,
120 mV RMS
Maximum Input Level: 6 dBV,
2VRMS
Effects Send:
Load Impedance: 1 K ohm
or greater
Nominal Output Level: -10 dBV,
0.3 V RMS
Effects Return:
Impedance: High Z, 22 K ohms
Designed Input Level: -10 dBV,
0.3 V RMS
(Switching jack provides Effects
Send to Effects Return connection
when not used)
System Hum & Noise
@ Nominal Input Level:
(20 Hz to 20 kHz unweighted)
68 dB below rated power
Equalization:
Special low, mid, & high passive
type EQ
Push Bright: +6 dB @ 2 kHz
Push Thrash: -20 dB notch @ 1 kHz
in Lead channel
Push Gain: Increases Lead gain
External Footswitch Functions:
Lead Channel Defeat (when selected
with button)
Reverb Defeat
REVERB LEVEL
I 9,
FOOT
SWITCH
BLOCK DIAGRAM
INTERNAL
SPEAKER _
8 OHM
4
POWER
AMP
5