Need help?Do you have a question about the Peavey TNT and is the answer not in the manual?
General| Inputs | 2 |
|---|---|
| Effects Loop | Yes |
| Channels | 1 |
| Speaker | 15 inch |
| Type | Bass amplifier |
| Preamp | Solid-state |
Two input jacks handle a wide range of input levels, with automatic gain balancing for simultaneous use.
Determines the input preamp gain, affecting sensitivity, not power output.
Active shelving type for boosting or cutting low frequencies, with flat response at vertical.
Controls the boost or cut amount for mid frequencies, with flat response at vertical.
Shifts the center frequency for mid-range peak or notch, from 150 Hz to 1.5 kHz.
Active shelving type for boosting or cutting high frequencies, with flat response at vertical.
Master gain control for the TNT, affecting overall amplifier output and dynamic range.
Outputs preamp signal, with two modes: with or without internal amp/speaker.
Indicates when the electrical supply is switched on and delivering power.
Three-position switch (Off, ON with ground, ON without ground) for power and grounding.
Three-wire line cord with proper grounding facilities for safety and reduced noise.
Two retainers on the rear panel for storing the mains cable during travel.
To Next Page