Need help?Do you have a question about the Peavey VSX 26 and is the answer not in the manual?
General| Type | Digital Signal Processor |
|---|---|
| Outputs | 6 x XLR |
| Inputs | 2 x XLR |
| Frequency Response | 20 Hz to 20 kHz |
| Dynamic Range | >110 dB |
| Input Impedance | 10 kΩ balanced |
| Crossover | Yes, fully adjustable |
| EQ | Yes, parametric |
| Limiter | Yes, per output |
Read and follow instructions, avoid water, clean with dry cloth, ensure ventilation, avoid heat sources.
Warning about permanent hearing loss from high noise levels and OSHA exposure limits.
Lists 3 inputs/6 outputs, 48 kHz sample rate, USB ports, XLR connections, and phantom power.
Details RTA Mic input, Data Wheel, LCD Display, and parameter select buttons (Setup, EQ, DYNAMICS, XOVER, DELAY, TOOLS).
LEDs for channel status and signal level, mute switches, and USB ports for storage and computer interface.
Details IEC power input/fuse holder, XLR male outputs, and XLR female inputs (line/AES).
Configures input sensitivity (-10 dBV/+4 dBV), mute, analog/digital operation, and level/trim.
Toggles stereo/mono linking and configures phantom power and mic gain for inputs.
Controls signal generator parameters and input-to-output matrix assignment for routing.
Accesses and selects from 8 pre-programmed configuration templates with filter types and frequencies.
Allows adjustment of output levels for individual outputs 1-6.
Configures graphic EQ with bandwidth select, frequency, and level adjustments for inputs.
Selects and adjusts 5 independent filters (Parametric, Notch, EQ types) with frequency, BW, and level.
Configures Threshold, Ratio, Attack, Release, and Gain for dynamics processing on inputs/outputs.
Adjusts dynamics release time, gain compensation, and bypass function.
Sets up crossovers with filter types (Butterworth, Linkwitz-Riley), frequency, and level adjustments.
Configures input/output delay in ms, feet, meters, and toggles polarity (Norm/Reverse).
Allows saving current configuration to internal memory or USB, and loading presets.
Instructions for installing software updates via memory stick or USB connection.
Diagram showing signal path including FB, GEQ, COMP, DLY, MIX, BP, PEQ, and OUT modules.
Details audio channels (3 inputs/6 outputs), LED metering status, and mute function.
Lists input trim range, sensitivity, impedance, max level, CMRR, crosstalk, and dynamic range.
Details output full scale, impedance, dynamic range, THD, frequency response, and latency.
Specifies sample rate, digital processing, DSP cycle speed, and control/memory interfaces (USB).
Lists dimensions, weight, power requirements, consumption, and agency compliance listings.
To Next Page
