Peavey XR 680C - Input and Output Connectivity; Low Impedance & High Impedance Inputs

ENGLISH
OW 7 . llOl 2 * ■ "All W(
Ojt ft ow ajx rwn avo
1 2 3 4 5 6 7
8 9 10
BALANCED LOW IMPEDANCE INPUT (1)
For use with low impedance microphones or low level sources equipped with an XLR connector.
HIGH IMPEDANCE INPUT JACK (2)
For use with high impedance microphones or high level sources equipped with a !4 " phone plug.
NOTE: It is not possible to use both the Low and High Impedance inputs on any single channel simultaneously.
MAIN OUTPUT (3)
Provides signal from the main mix before the equalizer. Used primarily to feed an auxiliary amplifier/speaker
system. (See Figure 2)
MONITOR OUTPUT (4)
Provides the signal for an external monitor amplificr/speaker system. The level is determined by the channel
monitor and master monitor controls.
EFFECTS OUTPUT (5)
Output for supplying signals to external effects or signal processing equipment.
GRAPHIC INPUT (6)
Provides an input to the internal graphic equalizer/power amp. This is a switching jack, and a signal inserted
here interrupts the normal signal path from the main bus into the equalizer.
OPERATION NOTE: This jack permits the equalizer to be switched away from its normal input, to accept
an external signal to be equalized.
GRAPHIC OUT (7)
Provides access to output of internal graphic equalizer.
FOOTSWITCH (8)
For connection of a footswitch (optional) and is used to activate/dcfcat reverb.