Need help?Do you have a question about the Peavey XR 700C and is the answer not in the manual?
General| Type | Powered Mixer |
|---|---|
| Channels | 7 |
| Effects | Digital effects processor |
| Inputs | XLR |
| Outputs | XLR |
| EQ | 3-band |
Sets the channel reverb drive level. Works with master effects and reverb controls.
Active tone control (shelving type, ±15 dB) that varies the high frequency range.
Active tone control (peak/notch, ±15 dB) that adjusts the mid frequency range.
Active tone control (shelving type, ±15 dB) that varies the low frequency range.
Determines the channel's monitor mix level and is independent of other channel controls.
Determines the channel's level in the main mix. Operate near mid-point for balance.
Blends external effect with the main mix when used with Effects Out/Return.
Allows the Effects Return to be assigned to the Monitor.
Blends the reverb effect with the main mix.
Controls the tonality of the internal reverb.
Controls the overall volume level of the system.
Master control for all channel monitor sends, sets overall monitor mix level.
Determines effects level for internal reverb and Effects Out jack.
Provides ±12 dB equalization at each center frequency.
Two calibrated, 10-segment LED arrays indicate Main and Monitor levels.
Stereo jack for an insert point before channel equalization.
For low impedance microphones or low level sources with XLR connector.
For high impedance microphones or high level sources with 1/4" phone plug.
Use to connect line level signal to the power amplifier.
Provides output from the Graphic Equalizer.
Input to internal graphic equalizer/power amp; interrupts normal path.
Signal for an external monitor amplifier/speaker system.
Use to connect line level signal to the power amplifier.
Provides output from the Graphic Equalizer.
Input to internal graphic equalizer/power amp; interrupts normal path.
Output signal for external amplifier/speaker system, mixer, or tape deck.
Patches an effects device output back into the mixer; can serve as aux input.
Output for supplying signals to external effects or signal processing equipment.
Connects an optional footswitch to activate/defeat reverb.
Introduces external signals into mix buses for more channels.
Selects phantom power for all channels; 'Off' disables it.
For connection of external speaker(s); minimum total impedance is 4 ohms.
Three-position switch to minimize hum and noise from loudspeakers.
Press to 'On' position to turn on the unit.
Contains the fuse; replace with same type and value to avoid damage.
3-wire line cord with grounding facilities for safety and reduced shock hazard.
Details input/output levels, impedance, frequency response, and EQ parameters.
Details master output levels, headroom, and impedance.
Covers effects gain, phantom power, graphic EQ parameters, and filter details.
Details input sensitivity, output power, THD, compression, cooling, and protection.
Specifies power at clipping and frequency response at maximum output.
Includes slew rate, damping factor, total harmonic distortion, and dynamic range.
Outlines the 1-year and 90-day warranty periods for product parts and components.
Lists conditions that void the warranty and limitations on Peavey's liability.
Provides instructions for obtaining warranty service and required proof of purchase.
Details the process and importance of registering the product for warranty.
Covers basic usage, placement, ventilation, and handling of the product.
Instructions on power cords, grounding, servicing, and avoiding shock hazards.
Addresses risks of high noise levels and required hearing protection.
To Next Page
