Need help?Do you have a question about the Peavey XR 560 and is the answer not in the manual?
General| Type | Powered Mixer |
|---|---|
| Channels | 6 |
| Inputs | 6 XLR |
| EQ | 3-band |
| Effects | Digital effects |
| Frequency Response | 20Hz-20kHz |
Advisories on avoiding electrical shock, fire hazards, and exposure to water or moisture.
XLR input for microphones, offering low impedance and +15V phantom power.
1/4" unbalanced inputs for high impedance sources and line level signals.
Adjusts the input signal level for each individual channel within the mix.
Controls the channel's reverb level, sent to the master reverb effect.
Sets the channel's level in the monitor mix, independent of the main mix.
Bass frequency tone control (shelving ±15 dB at 70 Hz) for sound shaping.
Treble frequency tone control (shelving ±15 dB at 12 kHz) for sound shaping.
Specific controls for Channel 6, including Contour and Tape/Line inputs.
Introduction to controls and features affecting the overall system output and performance.
Monaural RCA outputs for connecting to tape decks or recording devices.
Interface for an optional footswitch to enable/disable the digital reverb.
1/4" output for external monitor systems, controlled by monitor mix levels.
1/4" unbalanced output for connecting to amplifiers, speakers, or other mixers.
Primary control for adjusting the overall volume of the system's main output.
Visual indicator showing when the unit is receiving AC power.
Master control for the monitor mix, setting the overall monitor output level.
Adjusts the overall level of the digital reverb effect in the main mix.
Indicates when the signal to the digital reverb is approaching clipping.
Adjusts the decay length of the digital reverb effect.
Modifies the brightness or tone of the reverb effect.
Helps identify and reduce audio feedback frequencies during operation.
Provides broad frequency equalization for room tuning and tone shaping.
Located on the rear panel for turning the unit's main power on or off.
Protective fuse; crucial for replacement to avoid warranty voidance and damage.
Connection point for the removable AC power cable.
1/4" jacks for connecting speaker cabinets to the built-in power amplifier.
Details input impedance, gain, and level parameters for all input types.
Provides output levels, load impedance, and connector types for various outputs.
Reports residual noise and signal-to-noise ratios for main and monitor outputs.
Lists power output, load impedance, and frequency response of the internal amplifier.
Manufacturer's warranty covering defects in material and workmanship for one year.
Outlines terms that void the warranty and limitations on coverage and remedies.
Instructions for completing and submitting the warranty registration card for service.
Essential safety guidelines for using electric products, including placement and ventilation.
Information on noise exposure limits and recommendations for hearing protection.
To Next Page
