Peavey XR 680C - Technical Specifications - Master & Power Amp; Master Section Performance; Power Amp Section Performance

SPECIFICATIONS
(continued)
POWER AMP SECTION
(400BH Module with DDT®)
Frequency Response:
+0, 1 dB, 10 Hz to 30 kHz @
200 W into 4 ohms
Rated Power & Load:
210 W RMS into 4 ohms
300 W RMS into 2 ohms
Power @ Clipping:
(Wo THU I kHz. 120 V AC
line) Typically:
130 W RMS into 8 ohms
225 W RMS into 4 ohms
320 W RMS into 2 ohms
Intermodulation Distortion:
Less than 0.1%, 200 mW to
200 W RMS. 60 Hz & 5 kHz.
4 ohms. Typically below .05%
Total Harmonic Distortion:
Less than 0.1 c /o. 200 mW to
200 W RMS. 20 Hz to 10 kHz.
Typically below .05%
DDT® Dynamic Range:
Greater than 26 dB
DDT" Maximum THI):
(1 kHz)
Below 0.5% THD for 6 dB
overload
Below m THD for 20 dB
overload
Hum & Noise:
90 dB below 200 W, 20 Hz to
20 kHz
Slew Rate:
Greater than 15 V/uScc
Damping Factor:
Greater than 100 @ 1 kHz,
4 ohms
Input Sensitivity:
1 V RMS for 200 W into
4 ohms
Input Impedance:
22 K ohms, overload protected
Power Requirements:
(Domestic)
800 W. 120 V AC, 50/60 Hz