Owner’s Manual
Page 12
To obtain the best growl from BUZZ basses, the neck should be adjusted very straight
(no forward bow) and the pickups should be adjusted as close to the strings as
possible without getting hit when played. Also cutting too much midrange from the
tone at the amplifier may reduce growl.
On BUZZ basses, the most accurate intonation is achieved by fingering the note
directly over the fret marker.
Cleaning and polishing can be done with a fine liquid compound such DuPont #7
Auto polish or equivalent. This will remove all grime and glaze any small scratches.
Do not use any "guitar polishes" that contain wax or polymers. These only build up on
top of the finish and are not as durable or lustrous as the polyester itself.
Each time you change your strings you should clean the fingerboard (fine Scotch Brite
pad or a cloth, no steel wool or Brillo) and apply a fine coat of oil (tung oil mixtures
are best). Let dry a few minutes, then wipe all excess oil from the fingerboard. This
To Next Page
Loading...