EasyManua.ls Logo

Peg-Perego Orion - Mounting and Assembling; Mounting and Assembling the Child Seat

Peg-Perego Orion
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Orion Instruction Manual - Peg Perego
3
the bicycle.
22) A front mounted seat can reduce the manoeuvrability of the
handlebar.
23) Check the existence of any laws present in your State that
govern the use of bicycle seats to carry children.
24) Ensure that there are no sharp edges that could come into
contact with the child (for example, frayed or deteriorated wires
etc.).
25)Coveranysaddlespringstoavoidachild’sngersbeing
trapped and/or squashed by them.
26) The child in the seat must be clothed and protected from the
cold more than the person riding the bicycle. Protect the child
from rain.
27) Do not use the seat if any part is missing or broken.
28) The seat material (polypropylene) loses some of its mechanical
properties with ageing if exposed for longer periods to
environmental conditions (sun, rain, ice, etc.). In the case of
normal use and exposure to environmental conditions, the seat
should be replaced after 3 years.
WARNING!
Failuretocomplywiththemanufacturer’sinstructionscanleadto
serious injury or death of the passenger/rider!
Mounting and Assembling the Child Seat:
Illustration 1:
Holding the seat upside-down, insert the support arm (6).
Illustration 2:
After having lifted up the padding in the seating area, insert the
shortest two screws (10) in the holes.
Illustration 3:
Placethexingplate(12)incorrespondencewiththescrews(10)
protruding from the bottom of the seat. Attach the clamp using the
two M6 hexagonal nuts with the toothed washers.
Illustration 4:
With the screws loosened, place the support arm in one of three
possible positions, then tighten the nuts using the wrench (14) until
they are tightly fastened.
Illustration 5A-5B
Choose the plastic reduction (11) which is adapted to the diameter
ofthebicycle’sheadtubeandinsertitinthefasteningblock(7).
Each reduction shows the reference diameters. Apply the covers
(9) to the U-shaped brackets (8). Choose one of the possible
congurationsbasedonthetypeofbicycleframeyouhave,as
Orion_InstructionManual-Text.indd 3 12/02/14 15:47