GENERALITY
Good steam distribution to obtain the wanted humidity level in any ambient, is linked to 2
main variables:
the amount of steam introduced in ambient and its distribution.
In fact, if the steam is not homogenously introduced in ambient, areas full or lacking in humidity
are created, causing excessive condensation and difficult control of steam output, triggering a
"swinging" effect.
It is advised to introduce steam using a PEGO steam distributor, inserting it inside the ventilation
duct or in front of a fan unit where wanting to direct introduction in an ambient without duct.
EXAMPLE OF DISTRIBUTION IN DUCT
The PEGO steam distributor must be
inserted transversally to the air flow in the
duct.
To improve distribution yield, the distributor
must cover as much air flow width as
possible.
(fig. 41).
Fig. 41
To Next Page
Loading...
