What to do if Pelican Water Technologies Water Dispenser is backwashing but not using salt?
If your Pelican Water Technologies Water Dispenser system is backwashing but not using salt, the salt may have bridged. This means too much salt was added, forming a solid block. Try shaking the brine tank until the salt block breaks apart.
How to fix a Pelican Water Technologies PS48 Water Dispenser tank that is leaning?
If the tank of your Pelican Water Technologies Water Dispenser leans or isn't level, lift it straight up about 6 inches and tap it on the ground until it stands vertically. The tank's round bottom and boot design allow it to stand upright.
How to stop a Pelican Water Technologies PS48 from leaking at the top?
If water is leaking at the top of the tank around the head of your Pelican Water Technologies Water Dispenser, try tightening the head. Turn the head until it's snug, but avoid overtightening, as the tank head is designed to be hand-tight.
General| Brand | Pelican Water Technologies |
|---|---|
| Model | PS48 |
| Category | Water Dispenser |
| Language | English |
To Next Page
