Pella architect series Service Instruction

© 2014 Pella Corporation Page 1 of 7 Rev. 02/28/14
Part Number:80GA0003
Note: The screen remains in the track while the track is
removed and/or installed.
A. Locate the Cord / screen holder with the cord
attached, disconnect the cord from the holder.
These instructions apply to:
Architect Series
®
12/2004-Current
Designer Series
®
3/2005-Current
Tools Required:
• #2 Phillips head screwdriver
1
Removing The Screen Track, Screen and Screen Rollers
1B 1B
5/2011 - Current: One-Piece Track
1A
1B
1B
B. Locate the four screws at the head of the door frame
and turn each screw counter-clockwise to remove.
The screw at each end of the track is the attachment
screw for the factory-installed cord / screen holder.
Note: OXXO (4-panel) doors use two screen tracks which
meet in the center. Remove each track separately as
described above.
Note: Clip design may vary slightly from clips shown here.
C. When the screen track and screen are removed
from the frame, slide the screen track off of the
rollers on the top of the screen.
1C
1C
3/2014-Current
2004-3/2014
Sliding Door Screen and Screen Track Replacement
Service Instruction

Pella architect series Specifications

General

Glass Options	Obscure, Decorative
Energy Efficiency	Low-E Glass, Insulated Frames
Customization	Custom sizes
Product Type	Entry Doors, Patio Doors
Hardware Finishes	Oil-Rubbed Bronze
Security Features	Multi-Point Locking Systems, Impact-Resistant Glass
Warranty	Limited warranty; specific terms vary by component and application. Refer to Pella's written warranty for details.
Hardware	handles, hinges
Color Options	Wide range of colors and finishes