pellenc AIRION - Tool Stops During Use; Unusual Noise or Vibration

14
INCIDENTS
Repaired by
PELLENC approved
dealer
PELLENC approved
dealer
User User User User User User
PELLENC approved
dealer
Solutions
Change the trigger or
sensor
Change the cord
Allow tool to cool for
approximately 5 minutes
Recharge the battery (if
less than 10%)
Clean the duct
Clean or replace the
rotor
Clean or replace the
grille
Clean the rotor
Replace the rotor
Checks
At PELLENC approved
dealer premises
Check the condition of the
cord
4 beeps on the battery
When stopped, check
the battery charge level
indicated on the side
display
Check the condition of
the duct
Check the condition of
the rotor
Check the condition of
the grille
Check the condition of
the rotor
Probable cause
A trigger no longer functions
The power cord is sectioned
The tool has reached its
temperature limit
The battery is discharged
Air ow duct obstructed or
blocked (air intake elbow,
blowing tube, nozzle, etc.)
Dirty or damaged rotor
Blocked air intake grille
Dirty or damaged rotor
Condition
of diodes
On
Off
On On
Condition of
battery start/stop
switch
I
I I
Symptoms
The tool stops
during use
The blower
makes an
unusual noise
or vibrates
abnormally
Loss of efciency
of the air ow