Pelonis PHO15A2AGW - Troubleshooting

The plug
overheats or
ignites
Burnt odor and
inability to operate
(caused by the
accumulation of
dust inside)
• The current overload of the
socket or the aging of the
socket causes the contact to
loosen, prolonged use can
easily lead to overheating or
ignition of the plug.
Highly recommended that
users use sockets that meet
the requirements and
standards of their respective
countries or regions.
• The machine is used in an
environment with a lot of dust
or hair.
Recommended to place the
machine in a clean and
well-ventilated area.
TROUBLESHOOTING
If the product does not operate or does not operate properly, first check according to
the following list. If the reason the product does not operate or does not operate
properly is not included in the following list, the product may have failed. At this time, it
is recommended to send the product to the dealer for treatment.
Solution
Cause SolutionProblem
After the power is
engaged, the
machine does not
work.
The machine
suddenly stops
during heating.
• The plug may not be in
plugged in well.
Check whether the plug is
properly inserted into the
receptacle.
• The temperature exceeds the
threshold of the thermal cut-
off.
Unplug the heater and cool the
machine before use.
09