UNPACKING AND SET-UP
INSTRUCTIONS
Unpack your heater and find the wheel holding plates and butterfly nuts between the fin
assemblies.
1. Make sure the heater is unplugged and the
power and setting control is in the "OFF”
position.
2. TURN THE HEATER UP SIDE DOWN.
3. Attach the wheel holding plates onto the
heater as Fig.1 shows. One is fixed between the
last two fins and the other one is fixed next to
metal control box.
4.Insert the butterfly nuts and tighten them
securely.
5. TURN THE HEATER UP RIGHT.
Butterfly nuts
Wheel holding
plate
Metal control box
CAUTION
Risk of fire - Do not operate heater without wheel assemblies attached. Operate heater
in upright position only (wheels on bottom, controls on top). Any other position could
create a hazardous situation.
Fig.1
06
To Next Page
Loading...
