EasyManua.ls Logo

Pelpro FPP User Manual

Pelpro FPP
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Toll Free Technical Support
1 - 866 - 456 -9269
FPP
Bay View Freestanding
IPP
Bay View Insert / Built-In
FPP
Freestanding
IPP
Insert / Built-In
II or III
with Memory& Fan Trim
READ THIS ENTIRE MANUAL BEFORE YOU INSTALL AND USE YOUR HEATER.
FAILURE TO FOLLOW INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE,
BODILY INJURY OR EVEN DEATH!
Installation shall conform to CAN/CSA B365 Installation Code for Solid-Fuel-Burning Appliances and
Equipment in Canada and NFPA 211 Chimney, Fireplaces, Vents and Solid Fuel Burning Appliances in the USA
.
Contact local building or fire officials to obtain a permit and information on any installation requirements
and installation inspection requirements in your area.
Rev. A, 01/2009
Question and Answer IconNeed help?

Do you have a question about the Pelpro FPP and is the answer not in the manual?

Pelpro FPP Specifications

General IconGeneral
BrandPelpro
ModelFPP
CategoryPellet stove
LanguageEnglish

Summary

SAFETY PRECAUTIONS

AUTOMATIC SAFETY FEATURES

L120 Low Limit Switch Function

Shuts off stove when exhaust temperature drops below 120°F.

F140 Fan Limit Switch Function

Controls room air fan based on stove temperature.

L250 High Limit Switch Function

Shuts off stove if firebox temperature reaches 250°F.

Vacuum Switch Function

Detects vacuum in exhaust system and stops auger.

Hopper Lid Switch Function

Stops auger when hopper lid is open to prevent injury.

SPECIFICATIONS

HEATING SPECIFICATIONS

Details on heating capacity, burn rate, and hopper capacity.

DIMENSIONS

Diagrams and measurements for different stove models.

ELECTRICAL SPECIFICATIONS

Electrical rating, power consumption, and surge protection.

PLANNING-EXHAUST SYSTEMS ... CONTINUED

DETERMINE VENTING SIZE AND DISTANCE

Method for determining correct vent size and length.

PLANNING-PROTECTION & CLEARANCES

STOVE PLACEMENT

Guidelines for positioning the stove safely and effectively.

FLOOR PROTECTION REQUIREMENTS

Requirements for floor protection materials and installation.

MINIMUM CLEARANCES TO COMBUSTIBLES

Specific clearance distances to combustible materials.

INSTALLATION—FREESTANDING

THROUGH THE WALL, DIRECT VENT INSTALLATION

Step-by-step guide for through-the-wall vent installation.

MOBILE HOME INSTALLATION

FIREPLACE INSERT INSTALLATION

Full Chimney Reline Installation

Recommended installation for full chimney reline.

BUILT-IN INSERT INSTALLATION

BUILT-IN INSERT INSTALLATION ... CON'T

MINIMUM FRAMING DIMENSIONS

Table of minimum framing dimensions for built-in units.

OPERATING INSTRUCTIONS

Initial Appliance Start-Up Procedure

Critical steps for the initial appliance start-up.

CHOOSE MODE OF OPERATION

Guide to selecting operating modes (Manual, Thermostat).

OPERATING IN THERMOSTAT HIGH / LOW CYCLE

How to operate the stove using the thermostat in High/Low cycle.

OPERATING IN THERMOSTAT_ON / OFF

How to operate the stove using the thermostat in On/Off mode.

Air Inlet Damper Adjustment

Instructions for adjusting the air inlet damper for combustion.

OPERATING IN MANUAL MODE

Steps to start and operate the stove in manual mode.

Burn Grate Seating and Adjustment

Instructions for correctly seating and adjusting the burn grate.

OPERATING INSTRUCTION-LIGHTING YOUR APPLIANCE

Manual Stove Lighting (No Igniter)

Steps for lighting the stove without the auto-igniter.

Auto-Ignitor Stove Lighting

Steps for lighting the stove using the auto-igniter.

OPERATION-PERFORMANCE ENHANCEMENTS

GIVING YOUR APPLIANCE A “TUNE-UP”

Procedure for fine-tuning the appliance for optimal performance.

MAINTENANCE-ROUTINE CLEANING

YEARLY MAINTENANCE

TROUBLE SHOOTING

Tips for diagnosing and resolving common stove problems.

TROUBLE SHOOTING

Related product manuals