Pelpro PP60 Recommended Repair Procedures

August 5th, 2013
Recommended Repair Procedures
1 FLASH: EMPTY HOPPER.........................................................................(PAGE 5)
2 FLASHES: EXHAUST PROBE FAIL........................................................(PAGE 8)
3 FLASHES: AMBIENT PROBE ALARM....................................................(PAGE 7)
4 FLASHES: MISSED IGNITION.................................................................(PAGE 6)
8 FLASHES: EXHAUST OVER TEMPERATURE........................................(PAGE 3)
NOT LIGHTING THE FUEL:.........................................................................(PAGE 9)
CONVECTION BLOWER NOT COMING ON:..............................................(PAGE 2)
EXHAUST BLOWER NOT COMING ON:.................................................... (PAGE 10)
UNIT IS NOT SENSING TEMP IN THE ROOM:...........................................(PAGE 7)
LAZY OR SOOTY FLAMES:.........................................................................(PAGE 4)
NOT FEEDING PELLETS:...........................................................................(PAGE 11)
NO POWER:.................................................................................................(PAGE 12)
REFER TO THE OWNERS MANUAL FOR INFORMATION ON MAKING ADJUSTMENTS
TO THE UNIT OR FOR THE PROCEDURES FOR REPLACING PARTS.
WARNING!
ALWAYS UNPLUG THE STOVE BEFORE CLEANING, REPLACING
COMPONENTS, RESETING SNAP DISCS AND CHECKING WIRE
CONNECTIONS.
ALARM CODE
REPAIR PROCEDURE
SYMPTOM
PP60 PELLET STOVE

Pelpro PP60 Specifications

General

Hopper Capacity	60 lbs
Fuel Type	Wood Pellets
Vent Size	3"
Burn Time	Up to 40 hours
Ignition Type	Automatic
Thermostat	Yes
Weight	250 lbs