Pelton & Crane SP17 - User Manual

Questions and Answers

Y
Yolanda EnglishAug 6, 2025
What to do if the main control board fails in Pelton & Crane Dental equipment?
- B
  Brittney JonesAug 6, 2025
  If the main control board fails, the suggested solution is to replace the board.
N
Nicholas BowmanAug 10, 2025
Why did my Pelton & Crane SP17 chair stop due to loss of input signal?
- M
  matthewsscottAug 10, 2025
  If the chair stopped due to a loss of input signal, the input device or connection may be faulty. Examine them.
D
David TaylorAug 14, 2025
What to do if Pelton & Crane SP17 Dental equipment chair stopped due to no sensed motion?
- C
  Carol NovakAug 15, 2025
  If the chair stopped because no motion was sensed, examine the potentiometer.
L
Luis JonesAug 23, 2025
How to fix potentiometer value too low in Pelton & Crane Dental equipment?
- G
  George WaltersAug 23, 2025
  If the potentiometer value is too low, calibrate the potentiometer.
B
Brian RayAug 27, 2025
What to do if the error is for base potentiometer in Pelton & Crane SP17 Dental equipment?
- D
  debbiepearsonAug 27, 2025
  If the error is for the base potentiometer, examine the potentiometer.
T
Troy FrostAug 31, 2025
What to do if the error is for backrest potentiometer in Pelton & Crane SP17 Dental equipment?
- C
  Chad TorresSep 1, 2025
  If the error is for the backrest potentiometer, examine the potentiometer.
S
sriceSep 10, 2025
How to fix potentiometer value too high in Pelton & Crane SP17?
- P
  powelldeannaSep 12, 2025
  If the potentiometer value is too high, calibrate the potentiometer.