To Next Page
L
Linda JordanAug 3, 2025
What to do if the main control board fails in Pelton & Crane Spirit 1700 SII Dental equipment?
- KKathryn EdwardsAug 3, 2025
If the main control board fails, the suggested solution is to replace the board.
What to do if the main control board fails in Pelton & Crane Spirit 1700 SII Dental equipment?
If the main control board fails, the suggested solution is to replace the board.
Why did my Pelton & Crane Spirit 1700 SII Dental equipment chair stop due to loss of input signal?
If the chair stopped due to a loss of input signal, the input device or connection may be faulty. Examine them.
What to do if Pelton & Crane Spirit 1700 SII Dental equipment chair stopped due to no sensed motion?
If the chair stopped because no motion was sensed, examine the potentiometer.
How to fix potentiometer value too high in Pelton & Crane Spirit 1700 SII?
If the potentiometer value is too high, calibrate the potentiometer.
How to fix potentiometer value too low in Pelton & Crane Dental equipment?
If the potentiometer value is too low, calibrate the potentiometer.
What to do if the error is for base potentiometer in Pelton & Crane Spirit 1700 SII Dental equipment?
If the error is for the base potentiometer, examine the potentiometer.
What to do if the error is for backrest potentiometer in Pelton & Crane Dental equipment?
If the error is for the backrest potentiometer, examine the potentiometer.
General| Brand | Pelton & Crane |
|---|---|
| Model | Spirit 1700 SII |
| Category | Dental equipment |
| Language | English |
Control of the chair is possible with a multifunction foot switch and backrest or unit-mounted touchpad.
The base safety plate stops downward movement of the chair base if an object obstructs it.
The chair has automatic positioning programming, storing two automatic positions using potentiometers.
Calibrating the base potentiometer by adjusting the set screw on the large gear.
Soft limits define minimum and maximum values for base and backrest potentiometer travel.
Manually position the chair and use the LEARN button to store desired exit or operate positions.
Press the auto button once to recall a stored position.
