Need help?Do you have a question about the PEMTECH Ultra 1000 Series and is the answer not in the manual?
Instructions for mounting the detector to various surfaces.
Procedure for correctly installing the battery pack into the detector.
Steps to power on and off the wireless detector using the magnetic wand.
Guide to assigning unique addresses and zone IDs for sensor communication.
Procedure to adjust the sensor's zero set point without full calibration.
Information on common calibration errors, their causes, and solutions.
Details about the PemTech Smart Power Pack and its components.
Instructions and indicators for recharging the battery pack.
Step-by-step guide for replacing the sensor head assembly.
General| IP Rating | IP66 |
|---|---|
| Target Gas | Oxygen (O2), Combustible gases (LEL) |
| Sensor Type | Electrochemical, Catalytic bead, Infrared |
| Detection Range | 0-30% O2 (Oxygen) |
| Operating Temperature | -20°C to +50°C (-4°F to +122°F) |
| Operating Humidity | 0-95% RH (non-condensing) |
| Enclosure | Robust polycarbonate with rubber armor |
| Certifications | UL, CSA, ATEX, IECEx |
| Output Signal | 4-20 mA |
| Display | LCD with backlight |
| Alarms | Visual (LED), audible (95 dB), vibration |
| Battery Life | Not applicable (continuously powered) |
| Data Logging | Yes, with configurable intervals |
| Connectivity | HART (optional) |
To Next Page
