Need help?Do you have a question about the PEMTECH PT2000/H Series and is the answer not in the manual?
General| Ingress Protection | IP66 |
|---|---|
| Sensor Type | Electrochemical, Catalytic |
| Certifications | ATEX, IECEx, UL, CSA |
| Output Signal | 4-20mA, RS-485 Modbus |
| Power Supply | 24 VDC |
| Detection Gases | Oxygen |
| Detection Principle | Electrochemical, catalytic bead |
| Measurement Range | 0-100% LEL (Combustible) |
| Accuracy | ±2% FS (typical) |
| Response Time | <30 seconds (T90, gas-dependent) |
| Display | LCD with backlight |
| Communication | RS-485 Modbus |
Step-by-step instructions for the initial setup and verification of the system.
Procedure for installing a SIM card into the controller for cellular communication.
Details and diagrams for wiring audio and visual alarm devices to the controller.
Steps to connect the main AC power supply to the controller unit.
Setting alarm levels for different sensor types and associated relays.
Overview of the main display showing sensor locations, types, and readings.
Functions of the Alarm Reset and Alarm Bypass buttons on the display.
How to mount detectors and solar modules on poles.
Steps for powering up the wireless detectors for the first time.
Assigning unique addresses and network IDs to wireless sensors.
Troubleshooting common errors encountered during sensor calibration.
To Next Page
