EasyManua.ls Logo

pendoo Vacuum Sealer Machine - Sealing Failures and Air Leakage; Bag Melting and After-Sales Support

pendoo Vacuum Sealer Machine
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
No sealing after vacuumed
1. The machine is equipped with a vacuum pressure sensor. When the pressure inside the vacuum
packaging bag does not reach this preset pressure, the machine will not seal auto matically. Check
that the lower and up per sealing strips have no de bris and are in the correct position. Wipe them
clean a nd place them in the correct position and operate again.
2. Make sure that the upper and lower seals are not deformed or damaged.
3. The vacuum packaging bag ma
y be leakin g. If air bubbles are produced to prove that the
vacuum packaging bag is leaking, reseal it or replace it with another vacuum packaging bag.
4. Air leakage may be caused by folds, tears, foreign objects or other liquids at the opening of the
vacuum packaging bag. Open the vacuum packaging bag, wipe the port part and flatten the bag to
ensure that there are no folds or damage.
After sealing, air enters the vacuum packaging bag again
1. Air leaks may be caused by fold s , tear
s, foreign objects or other liquids at the mouth of the
vacuum packaging bag. Open the vacuum packaging bag, wipe the port section and stretch the bag
flat to ensure that the re are no folds or tears.
2. Air in the vacuum packaging bag may cause the food to ferment. Open the vacuum packaging
bag and discard the food if it has spoiled. Food that has not been placed in th e refrigerator or
fluctuating temperatures in the refrigerator can cause food to spoil.
3. Chec k the vacuum bag for da
mage. D o not wra p sharp items, suc h a s bone s or nut shells. Wrap
sharp parts in paper towels to prevent puncturing the vacuum bag.
Bag Melting
1.If the sealing silicone s trip s and sealing heating strips are overheating an d causing the vacuum
bag to melt, open the lid and allow the sealing silicone strips and sealing hea tin g strips to cool for
a few minutes.
2.If the sealing silica gel and the thermal fuse is excessively hot, bag melting might be caused.
Please open the bag to have
the s ealing silica gel and the thermal fu s e to cool down for a few
minutes.
Pendoo has be en dedicated to providing great online shopping experience with the qu ality
products and top-tier support.
Customer satisfaction is one of ours biggest priorities. PENDOO provides 24-hours customer
support. No matter what problem you met with our Pendoo products, you can always get a timely
and professional solution from Pendoo. Please feel free to reach us if any issue
Customer Service Center: pendoo.service@gmail.com
After-Sales Service