Pendulum CNT-90 - 1 Preparation for Use

III
Table of Contents
1 Introduction
Introduction ................ 1-2
About this Manual............ 1-2
Warranty................. 1-2
DeclarationofConformity .......1-2
Safety Precautions ............. 1-3
CautionandWarningStatements....1-3
Symbols................. 1-3
If in Doubt about Safety .........1-4
2 Preparation for Use
Unpacking................. 2-2
CheckList................ 2-2
Identification .............. 2-2
ReadingtheElectronicManuals......2-2
Installation................. 2-2
Supply Voltage ............. 2-2
Setting ................ 2-2
Fuse.................. 2-2
Grounding ................ 2-3
RearPanel................ 2-3
LinePowerInlet ........... 2-3
ReferenceOutput........... 2-3
External Reference Input .......2-3
External Arming Input ........2-3
GPIB/IEEE-488 Connector ......2-3
USBConnector............ 2-4
Optional Main Input Connectors . . . 2-4
Fan.................. 2-4
TypePlate............... 2-4
OrientationandCooling.........2-4
Fold-Down Support ...........2-4
Rackmount Adapter ...........2-4
3 Operating the Counter
Introduction ................ 3-2
UserInterface............... 3-2
Getting Familiar with the Counter .....3-2
DescriptionofKeys............ 3-3
Power.................. 3-3
SelectFunction............. 3-3
Autoset/Preset.............. 3-3
MoveCursor .............. 3-3
Enter................... 3-3
Exit/OK ................. 3-3
Cancel.................. 3-3
PresentationModes...........3-4
VALUE................ 3-4
STAT/PLOT.............. 3-4
Remote................ 3-5
HardMenuKeys ............ 3-5
Input A ................ 3-5
Input B ................ 3-5
Settings................ 3-6
Math/Limit.............. 3-7
UserOptions............. 3-8
Hold/Run............... 3-9
Restart ................ 3-9
EnteringNumericValues........3-9