A higher value means faster settling time.
By depressing this key twice within two seconds, you will enter the Preset mode, and a more extensive automatic
setting will take place. In addition to the functions above, the following functions will be performed:
Set Meas Time to 200 ms
Switch off Hold-Off
Set HOLD/RUN to RUN
Switch off MATH/LIM
Switch off Analog and Digital Filters
Set Timebase Ref to Auto
Switch off Arming
Default Settings
An even more comprehensive preset function can be performed by recalling the factory default settings. See page 2-16.
3.3.4. Move Cursor
There are four arrow keys for moving the cursor, normally marked by text inversion, around the menu trees in two
dimensions.
3.3.5. Display Contrast
When no cursor is visible (no active menu selected), the UP/DOWN arrows are used for adjusting the LCD display
contrast ratio.
3.3.6. Enter
The key marked ENTER enables you to confirm a choice without leaving your menu position.
3.3.7. Save & Exit
This hard key is marked EXIT/OK. You will confirm your selection by depressing it, and at the same time you will leave
the current menu level for the next higher level.
3.3.8. Don't Save & Exit
This hard key is marked CANCEL. By depressing it you will enter the preceding menu level without confirming any
selections made at the current level. If the instrument is in REMOTE mode, this key is used for returning to LOCAL
mode, unless LOCAL LOCKOUT has been programmed.
3.3.9. Presentation Modes
VALUE
20 / 50
To Next Page
Loading...
