Advanced menu
You can use the Advanced menu to change the parameter values in the Basic menu and the
parameter values for the following advanced parameter codes:
• Temperature Units (Un)
• Low Temperature Setpoint Stop (LtS)
• High Temperature Setpoint Stop (HtS)
• Anti-Short Cycle Delay (ASd)
• Defrost Cycle Time (dFt)
• Defrost Interval (dI)
• Binary Input Mode (bLn)
• Backlight Brightness Level (bLL)
• Temperature Setback (tSb)
• Sensor Offset (So)
• Sensor Failure Option (SO)
• Start or Stop Defrost Cycle (SdF)
See Parameter codes and modes of operation and Table 3 for more information about parameter
codes, usable parameter values, and default values.
15A421 Series Electronic Temperature Controls with Off-Cycle Defrost Installation Guide
To Next Page
Loading...
Need help?
General
