6
www.PennBarry.com
10. Check that bearing temperatures are not excessively hot.
11. Check that all bolts and hangers are secure after one (1) hour of continuous operation.
Guard and Protect All Moving Parts
All motors are checked prior to shipment. However, if motor defects should develop, prompt service can be obtained from the
nearest authorized service station of the motor manufacturer under the warranty. Exchange, repair or replacement will be provided
on a no charge basis if the motor is defective within the warranty period. Do not return defective motors to PennBarry. Motor
guarantee is void unless overload protection is provided in motor wiring circuit.
NOTE: Take care to follow all local electrical, safety and building codes. Follow provisions of the National Electrical Code as well as the
Occupational Safety and Health Act.
Always disconnect power source before working on the unit.
CAUTION
START-UP AND OPERATION
Incorrect rotation overloads motor severely and results in serious motor damage. To change rotation of three phase units,
simply interchange any two of the three line leads. On single phase units, change the terminal block set-up following the
wiring diagram.
CAUTION
To Next Page
Loading...
