PennBarry DYNAMO - Maintenance

7
www.PennBarry.com
Lubrication Schedule
Always follow the bearing manufacturer’s recommended lubrication schedule. If none is available, use the following general schedule:
1. Under average conditions where ambient temperatures do not exceed 120°F., lubrication is required 1 to 2 times a year.
2. In dirt laden atmospheres where there is a temperature range of 120°F to 150°F, lubrication is required from 3 to 6 times a year.
3. Under extreme temperature conditions and extremely dirty atmospheres, lubrication should be scheduled at least once or twice
a month.
4. Belt drive units maximum temperature should not exceed 160°F. Direct driven models have temperature range stamped on
motor.
Motor Lubrication
In general, standard motors are furnished with prelubricated, sealed-for-life ball bearings which require no lubrication for 7 to 10
years of normal service. Where motors have been ordered with greasable bearings, these bearings are factory lubricated and require
no attention for one year under normal conditions. If grease relief ttings are provided, remove them when performing maintenance
to allow grease to ow out. Whenever possible, apply grease while the motor is running. This practice should not supersede any
safety considerations. DO NOT OVERGREASE, as most lubricants deteriorate motor windings, thereby reducing motor life.
Use low pressure grease guns only. High pressure guns tend to blow out or unseat bearing seals, leaving the bearing open
to collect grime, dust and foreign particles.
CAUTION
MAINTENANCE
Do not attempt maintenance on fan until the electrical supply has been completely disconnected. If a service switch has not been
provided, remove all fuses from the circuit and lock the fuse panel so they cannot be accidentally replaced.
Lubrication is a primary maintenance responsibility. Check all bearings periodically. Inspect belts for tightness. If the fan is installed in
a corrosive or dirty atmosphere, periodically clean the centrifugal wheel, inlet, motor housing and other moving parts.
Fan Shaft Lubrication (Belt Drive models only)
Fan shaft bearing pillow blocks are furnished in either the prelubricated sealed-for-life type or the greasable type depending on
what was ordered. The prelubricated type requires no servicing for 7 to 10 years of normal use, and the greasable type are factory
greased eliminating the need for greasing initially. Follow the lubricating schedule recommended by the factory. This practice should
not supersede any safety considerations.
Recommended Lubricants
Manufacturer Product Temp. Range
BP LG-#P-1
Below 32°F (0°C)
Gulf Gulfcrown EP-1
Imperial Oil Unirex EP-1
Shell Alvania R-1
BP Energrease, MPMK11
32°F to 150°F (0°C to 66°C)
Gulf Gulfcrown EP-2
Imperial Oil Unirex EP-2
Shell Alvania R-3
Sun Oil Sun Prestige 42
Texaco Regal AFB2