What to do if Pentair Pool Products SuperFlo won't prime and the pump strainer is clogged?
If your Pentair Pool Products Swimming Pool Pump won't prime and the pump strainer is clogged, ensure the suction lines, pump strainer, and pump volute are full of water. Verify the suction line valve is working and open. Also, check the water level to ensure water is available through the skimmer, and clean the pump strainer pot.
How to fix Pentair Pool Products SuperFlo failure to pump with too much air?
If your Pentair Pool Products Swimming Pool Pump fails to pump due to too much air, check the suction piping and valve glands on any suction gate valves. Ensure the lid on the pump strainer pot is secure and the lid gasket is in place. Also, verify the water level to ensure the skimmer isn't drawing air.
How to clean a clogged impeller in Pentair Pool Products SuperFlo Swimming Pool Pump?
If the impeller of your Pentair Pool Products Swimming Pool Pump is clogged: 1. Turn off electrical power to the pump. 2. Remove the clamp holding the volute to the seal plate and slide the motor and seal plate away from the volute. 3. Clean debris from the impeller. If debris can't be removed: 4. Remove the left-hand thread anti-spin bolt and O-ring. 5. Remove, clean, and reinstall the impeller. 6. Reinstall the anti-spin bolt. 7. Reinstall the diffuser and quad ring. 8. Reinstall the motor and seal plate into the volute. 9. Reinstall the clamp around the seal plate and volute and tighten securely.
Warning about electrical hazards during pool pump installation and servicing.
Caution regarding pressurized air and potential for equipment parts to blow off.
Covers voltage, wiring gauge, and bonding requirements for pump installation.
General| Brand | Pentair Pool Products |
|---|---|
| Model | SuperFlo Swimming Pool Pump |
| Category | Swimming Pool Pump |
| Language | English |
To Next Page
