To Next PageTo Next Page
Need help?Do you have a question about the Pentair AQUALUMIN III and is the answer not in the manual?
General| Cord Length | 50 ft |
|---|---|
| Lens Material | Polycarbonate |
| Life Span | 50, 000 hours |
| IP Rating | IP68 |
| Type | LED |
| Voltage | 12V |
| Housing Material | Polymer |
Steps for electricians to prepare the pool's electrical system before light installation.
Location requirements for junction box or transformer relative to water and deck.
Bonding requirements for light fixture and nearby metal items for electrical safety.
Steps to perform after ensuring electrical system requirements are met.
Attaching gasket and mounting bracket before liner installation.
Managing excess cord length on the back of the light assembly for servicing.
Feeding cord through hub and securing the light fixture housing.
Preparing and connecting light fixture cord to junction box wires, ensuring GFCI compliance.
Connecting wires in junction box and filling pool for operational check.
Guidance on winterizing the light fixture; it should remain installed.
Preparatory steps for electricians before replacing an existing light fixture.
Location requirements for junction box or transformer relative to water and deck.
Bonding requirements for light fixture and nearby metal items for electrical safety.
Mounting bracket installation depth requirement relative to water surface.
Consulting local building department for compliance with electrical codes.
Using only specified Pentair mounting brackets for proper bonding and grounding.
Steps for replacing the light fixture after electrical system readiness.
Turning off power and removing the old light assembly from the mounting bracket.
Disconnecting old wires, feeding new cord, and preparing for connection.
Connecting new wires in junction box and filling pool for operational check.
Turning off power and handling the light assembly safely before lamp replacement.
Removing captive screw, placing light face down, and loosening housing screws.
Removing specific screws and accessing the lamp by tilting the light housing.
Installing new lamp and reassembling housing with new gasket and sealing screws.
Tightening sealing screws, managing cord, and ensuring light submersion before operation.
