Pentair CC200 User Manual

Rev. D 6-26-09 1 P/N 178556
Figure 1.
Pentair Water Pool and Spa, Inc.
1620 Hawkins Ave., Sanford, NC 27330 • (800) 831-7133 • (919) 566-8000
10951 West Los Angeles Ave., Moorpark, CA 93021 • (800) 831-7133 • (805) 553-5000
Visit www.pentairpool.com or www.staritepool.com
Before installing this product, read and follow all warning notices and instructions accompanying this
filter. Failure to follow safety warnings and instructions can result in severe injury, death, or property
damage. Call (800) 831-7133 for additional free copies of these instructions.
WARNING
Important Notice
Attention Installer.
This manual contains important information about the installation, operation and safe
use of this product. This information should be given to the owner/operator of this
equipment.
SECTION I. FILTER INSTALLATION
A. GENERAL INFORMATION
1. The filter should be mounted on a level concrete slab. Position the filter so that the instructions,
warnings and pressure gauge are visible to the operator. Also, position the filter so that the piping
connections, control valve and drain port are convenient and accessible
for servicing and winterizing.
2. Install electrical controls (e.g., on/off switches, timers control systems,
etc.) at least five (5) feet from the filter. This will allow you enough
room to stand clear of the filter during system start up.
3. Provide sufficient clearance around the filter to permit visual verification
that the clamp is properly installed, see Figure 1.
4. Provide sufficient space above the filter to remove the filter lid for
cleaning and servicing. This distance will vary with the model of filter
you are using. See Table 1, for the required vertical clearance.
Clean & Clear
®
Cartridge Filter Owners Manual
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Table of Contents
SECTION I. FILTER INSTALLATION ............................................................................................... 1
SECTION II. FILTER OPERATION .....................................................................................................2
SECTION III. TROUBLESHOOTING................................................................................................... 6
SECTION IV. TECHNICAL DATA .......................................................................................................7
A. Filter Pressure Loss Chart.......................................................................................... 7
C. Replacement Parts ..................................................................................................... 7
B. Flow Rate Table ......................................................................................................... 7

Pentair CC200 Specifications

General

Brand	Pentair
Model	CC200
Category	Swimming Pool Filter
Language	English

Summary

Filter Installation

General Information on Filter Installation

Essential details on filter placement, clearance, and mounting requirements for safe and effective operation.

Lock Ring Installation Instructions

Crucial steps to properly install the lock ring to prevent lid blow-off during system restart or operation.

System Restart Instructions

Detailed procedure for safely restarting the filter system after servicing, emphasizing air relief and pump operation.

Cleaning the Filter

Guidance on when to clean filter cartridges based on pressure readings and the process for removing debris.

Replacing Cartridge Element

Information on the expected life of cartridge elements and the process for replacing them.

Cleaning the High Flow™ Manual Air Relief Valve

Instructions for cleaning the High Flow™ manual air relief valve to ensure proper system function.

Filter Operation

High Pressure Operation Safety Warning

Critical safety warnings for operating the filter system under high pressure to prevent injury or damage.

System Operation and Pressure Gauge

Details on how the filter operates under pressure and the function of the pressure gauge.

Filter Cleaning Indicator

Guidance on when to clean the filter based on pressure readings and the initial starting pressure.

Troubleshooting Common Issues

Identifying Air Entry Problems

Common causes and identification methods for air entering the filtration system, a critical safety concern.

Addressing Short Filter Cycles

Explanation of why short filter cycles might occur, especially with new pools or plaster dust.

Pressure Gauge Troubleshooting

Steps to troubleshoot pressure gauge readings and ensure it is functioning correctly.

Pump and Plumbing Obstruction Checks

Procedure to check for debris in pump baskets and potential obstructions in the plumbing lines.

Technical Specifications and Data

Filter Pressure Loss Chart

A graphical representation showing the relationship between water flow rate and pressure loss across the filter.

Flow Rate Data Table

A table detailing maximum cartridge flow rates for residential and commercial applications.

Replacement Parts List

An indexed list of all available replacement parts for the filter system with corresponding part numbers.