Pentair Pentek P42B0010A2-01 - Choosing a Pump System

101
Appendix
SECTION 14: Appendix
Ventilated
Well Cap
Submersible
Cable
Pitless
Adapter
Check
Valve
Tape Cable
To Pipe
Add Torque Arrestor
(especially needed with
plastic pipe)
Pump
Motor
Control Box
(3-wire Models)
Electrical Disconnect
Pre-charged Tank
Pressure Switch
Pressure Gauge
To House Service
Relief
Valve
Union
Gate Valves
“Good” System
Features
• PressureSwitch
• Wire,(10-2w/ground)
• 1.5HP,20-22gpmpump
• 1.5HP,2-wiremotor
• 85gal.Tank
• OptionalMotorProtection(SPP-233P)
Benefits
• Cost
• Simpletouse
• PENTEKPSCmotorofferslower
operating cost
“Better” System
Features
• ControlBox
• PressureSwitch
• Wire,(10-3w/ground)
• 1.5HP,20-22gpmpump
• 1.5HP,3-wiremotor
• 85gal.Tank
• OptionalMotorProtection(SPP-233P)
Benefits
• Capacitorsandswitchescanbe
replaced without removing pump
• CSCRcontroloffershigherefficiency
• Higherstartingtorquethan2-wire
“Best” System
Features
• VFD
• PressureTransducer
• Wire,(12-3w/ground)
• 1.5HP,20-22gpmpump
• 1.5HP,3-Phasemotor
• 6gal.Tank
Benefits
• “City-like”pressure
• Loweroperatingcosts
• Softstart/stop
• MotorprotectionbuiltintoVFD
14.2 Choosing A Pump System
A typical well application can be set up using one of three
electrical configurations for single-phase power. The
samples below are based upon a system using a 1.5 HP,
20-22 gpm pump, with 400 feet of wire from electrical
disconnect to the motor. All configurations shown are
suitable methods for residential applications.