Pentair PROWLER 910 - User Manual

Questions and Answers

C
christinewilsonAug 1, 2025
Why Pentair Ultrasonic Jewelry Cleaner does not reach all areas of the pool?
- B
  Bradley FrancoAug 1, 2025
  Your Pentair Ultrasonic Jewelry Cleaner might not be reaching all areas of the pool due to several reasons. The power supply may be positioned incorrectly, so place it in a position so that the cleaner can reach all walls. Also, there might be algae on the pool floor, in that case you should brush the pool floor. Another reason might be that the pool filter and pump are on, so turn them off and run another cleaning cycle.
M
Micheal ThompsonAug 6, 2025
What to do if my Pentair Ultrasonic Jewelry Cleaner cable is twisting?
- W
  walkermichaelAug 6, 2025
  If the cable of your Pentair Ultrasonic Jewelry Cleaner is twisting or coiling up, it could be due to a few reasons. There might be an obstruction in the pool, so remove it. The cleaner could be getting stuck on the main drain cover; in this case, turn off the filter and install a main drain cover ring. Another cause could be excess cable in the pool, so remove the excess cable.
J
John LawrenceAug 11, 2025
What to do if Pentair Ultrasonic Jewelry Cleaner is moving in circles?
- S
  Shawn HernandezAug 11, 2025
  If your Pentair Ultrasonic Jewelry Cleaner is moving in circles, it could be due to dirt stuck in the moving parts, so remove the dirt. Another reason could be worn tracks, so replace them. The power supply might be positioned incorrectly, so place it in a position so that the cleaner can reach all walls. Also, check if the bottom lid is mounted incorrectly and lock it in the right position. Finally, algae in the pool can cause this issue, so correct the pool and water conditions.
S
Shaun PorterAug 16, 2025
What to do if my Pentair Ultrasonic Jewelry Cleaner will not sink?
- S
  Sarah HessAug 17, 2025
  If your Pentair Ultrasonic Jewelry Cleaner won't sink, it could be because air is trapped inside; turn the cleaner upside down underwater to remove the trapped air. Also, try washing the cartridge, and remove any calcium deposits or other chemical sediments. Finally, open the inlet flap in the bottom lid to remove any dirt and/or trapped air.
M
Mary NelsonAug 21, 2025
Why the motor of my Pentair Ultrasonic Jewelry Cleaner is not working?
- J
  Jay ThomasAug 21, 2025
  The motor of your Pentair Ultrasonic Jewelry Cleaner might not be working because the impeller is blocked, so remove the impeller tube. Another reason could be a blocked drive system, so clean the tracks and wheels. If these steps don't resolve the issue, consult with your dealer or service center, as it may be an electrical problem with the motor unit, floating cable, or power supply.
W
wallacecarlosAug 26, 2025
What to do if the power supply switch light is not working on my Pentair Ultrasonic Jewelry Cleaner?
- Q
  qsotoAug 27, 2025
  If the power supply or power supply switch light is not working on your Pentair Ultrasonic Jewelry Cleaner, first, reconnect and check the main power supply to ensure it is properly plugged in. Also, check the main socket for any damage and reconnect the power supply.