Pentair PROWLER 910 - Cleaning the Impeller

KREEPY KRAULY
®
PROWLER
®
910 Robotic Aboveground Pool Cleaner Installation and User’s Guide
4
KREEPY KRAULY
®
PROWLER
®
910 Robotic Aboveground Pool Cleaner Installation and User’s Guide
Cleaning the Impeller
Always disconnect power to the cleaner before servicing, disassembly, or reassembly. Failure to do so could result in death or
serious injury to servicemen, pool users or others due to electrical shock. Read all servicing instructions before servicing the cleaner.
Every so often debris may become trapped in the Prowler
®
910 Robotic Pool Cleaner’s impeller. To clean out debris
trapped in the impeller opening, follow the instructions below:
STEP 2:
Remove Debris from Impeller Cover
By hand, clean as much debris as possible from the opening
of the cleaner’s impeller. See Figure 14.
Sometimes the debris may become lodged deeper in the
impeller where you can not reach it. If this is the case,
proceed to the next step to remove the impeller cover
Figure 14
STEP 3:
Unmount the Impeller Cover
Using a No. 2 Phillips-head screwdriver, remove the
two screws that hold the impeller cover in place. These
screws can be found in the bottom corners of the
impeller cover. See Figure 15.
Place the two screws to the side.
Figure 15
STEP 4:
Remove the Impeller Cover
Gently pull the impeller cover away from the cleaner
body. See Figure 16.
By hand, remove any debris that has become trapped
around the impeller.
Remount the impeller cover with two impeller cover
screws.
Figure 16
STEP 1:
Open the Filter Cover and Remove the Basket
See Figure 12 and Figure 13.
Figure 12
Figure 13