4
@
(t
6,,
oft
!
frl
u
J
o
z
!
u
m
!
v
=
o
3
3.
As shown
in the illustration,
pull
the film
leader
out only
far enough
to reach the take
-up
spool.
THE SHUTTER CURTAINS
ARE FINE-
PRECISION MATERIAL.
DO NOT TOUCH THEM
WITH YOUR
FINGERS OR ANY OTHER
OBJECT
WHILE LOADING FILM.
.
lf
you
have
pulled
out too much
film,
push
it back into
the cartridge to reduce
the
slack.
.
The DX information
pins
in the film chamber are used
to read film speed.
Keep them clean and free from
scratches. To remove smudges,
wipe them
gently
4. Align the film leader with
the film leader end
mark
O
as shown.
.
Make sure that the
film leader is
positioned
under
the
film retainer
O
as shown in the illustration.
.
Make sure that the'film
perforations properly
engage
on the sprocket tooth €).
.
lf the end of
the film leader is extremely
bent,
straighten it or cut off
the
bent
portion.
To Next Page
Loading...
