Pentax Zoom 60-X - Power Switch and Battery Check

2. POWER SWITCH AND BATTERY CHECK
Power switch
To switch on, push the power switch . The lens extends
slightly, and the lens cover opens. To switch off, push the
power switch again. Make sure the camera is switched off
when not in use.
Caution:
The lens cover automatically opens when the power is
turned on, and closes when the power is turned off. Never
attempt to open the lens cover by hand.
Battery check
After power is switched on. the lens extends slightly and
the lens cover opens. The camera is then ready to shoot.
Notes:
• When the camera is left unused with the power on for
over 3 minutes, its power automatically switches off.
• Use two 3 V lithium batteries (CR123A or DL123A). Do
not remove the batteries until they are exhausted, since
they are also used by the dale function on the DATE
model to keep constant track of time.
• Refer to page 27 for directions on battery insertion.