52
FCC Statement
WARNING:
Changes or modifications made to this equipment not
expressly approved by PEPPERL+FUCHS GmbH for
compliance could void the user’s authority to operate the
equipment.
FCC Statement
This Smart-Ex
®
02 variant targeted for the North American
region complies with part 15 of the FCC rules (FCC ID:
XAM500079GR01). Operation is subject to the following
two conditions:
This device may not cause harmful interference.
This device must accept any interference received,
including interference that may cause undesired
operation.
This device has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates,
uses, and can radiate radio frequency energy, and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
The country code selection is for non-US model
only and is not available to all US model. Per FCC
regulation, all Wi-Fi product marketed in US must
fixed to US operation channels only.
IC Notice
This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two
conditions:
this device may not cause interference, and
this device must accept any interference, including
interference that may cause undesired operation of the
device.
This Class B digital apparatus complies with Canadian ICES-
003 (IC: 8311A-500079GR01).
IC Radiation Exposure Statement
This EUT is in compliance with SAR for general population/
uncontrolled exposure limits in IC RSS-102 and had been
tested in accordance with the measurement methods and
procedures specified in IEEE 1528 and IEC 62209. This
equipment should be installed and operated with minimum
distance of 10 mm between the radiator and your body. This
device and its antenna(s) must not be co-located or operating
in conjunction with any other antenna or transmitter.
The use of WLAN band is restricted to indoor use only.
To Next Page
Loading...