Need help?Do you have a question about the Perfecta 168 TV and is the answer not in the manual?
Ensures machine safety regulations are met and periodic inspections are performed by specialists.
Configures control switches S52, S53, S54 for proper knife beam stopping at the upper dead centre.
Details the system design, armature disk, brake lining, and clutch lining for machine braking.
Annual check and adjustment of air gaps (A min, A max) for clutch/brake assembly using shims.
Describes the mechanical non-repeat device and its safety function for the knife beam.
Steps to calibrate the measuring system by entering actual measurement and recognizing the zero pulse.
Adjusting front (B39) and rear (B27) proximity switches for accurate measurement detection.
To Next Page
General