Switching WakeboardPro <> DigitalPro – If you system was selected
incorrectly, perform a system reset. As you proceed through this process, you
will be asked [Wakeboard Only ^ = YES]. Answer YES for WakeboardPro, and
NO for DigitalPro
Engine Selection – On initial start up or during a system reset, PerfectPass will
ask if you have a standard 5.7 litre engine. This will appear as [ 5.7 / MPI ^ =
Yes ] This means press UP for 5.7 and DOWN for Big Block 6L or 8.1L.
To confirm if correct engine was selected, press Menu & Up Keys together to get
into back ground screen and go to “System Settings”. Following battery
voltage, etc you will see which engine was selected. If incorrect, perform a
system reset.
(An incorrectly selected engine can cause unsettled control in rpm mode only)
WakeboardPro to/ DigitalPro – The Master Module for both systems are
identical. The only difference is in the way they were initialized, i.e. as a
DigitalPro or WakeboardPro. You can change the way it was set by performing a
system reset.
PerfectPass Control Systems (902) 468-2150 Page 7
To Previous Page
Loading...
Need help?
General