INSTALLATION SAFETY
OPERATION
1. Plug into any 110-125V 60Hz polarized outlet. Be aware of the plug and insert properly.
2. Pull cord out to desired length. Notice a clicking noise when pulling the cord.
The cord will stay at the desired length during the clicking and rewind after a pull past the clicking noise.
3. Extended length when retracted can be achieved by sliding the rubber stop on the cord to the desired position.
4. To retract, pull cord out and guide cord slowly back into the reel.
CAUTION: Outlet is energized at all time. DO NOT OVERLOAD!
NOTE: Cord length is 20 feet long fully extended. DO NOT pull on cord after cord is fully extended.
CAUTION: DO NOT ALLOW THE CORD TO RETRACT BY ITSELF AS DAMAGE OR INJURY MAY
OCCUR FROM EXCESSIVE REWIND SPEED.
Remove dirt and grime as soon as it accumulates. Use a soft damp cloth and a mild soup if needed. Be sure not to get the
electrical plug wet. NEVER submerge any part of the cord reel in any solution to clean it.
DO NOT USE solvents such as gasoline, turpentine, etc. to clean unit. Keep reel cord clean to maintain smooth retraction.
To clean, simply pull cord to its full length and allow to retract through a dampened rag. Pull out full length again and allow
to retract through clean rag sprinkled with talcum powder.
DRY THOROUGHLY BEFORE PLUGGING BACK INTO OUTLET.
WARNING: TO AVOID INJURY ALWAYS UNPLUG UNIT BEFORE PERFORMING ANY MAINTENANCE.
6. Do not install when tired or when under the influence of alcohol, drugs or medication.
7. Install the Cord Reel properly before connecting to the power supply.
8. If mounted in an area that is not readily accessible, connect this Cord Reel to a switch-controlled outlet; then, if a
malfunction occurs, the Reel can be disconnected immediately.
9. Install out of reach of children.
10. Verify that installation surface has no hidden utility lines before drilling or driving screws.
1. Select location within 2 feet of an electrical outlet (such as the receptacle near your garage door opener if available).
2. Locate a ceiling joist (using a stud finder) and mark the center on the drywall.
3. Attach a hook, clip, or other secure locking devise though which to hang the reel.
4. Attach the reel through the eyelet at the top and test to make sure reel will not fall when pulling out the cord.
CAUTION: DRYWALL WILL NOT HOLD THE WEIGHT OF THE REEL ASSEMBLY.
INSTALLATION
To Next Page
Loading...
Need help?
General
