Read these safety warnings before operation.
WARNING!
Failure to read, understand and follow these warnings may
result in loss of load, damage to unit, and/or failure of unit
resulting in personal injury or property damage.
WARNING!
Use this transmission adaptor only for the removal and instal-
lation of passenger car and light duty truck transmissions. Do
not overload beyond 300 lbs. Do not remove or install trans-
missions with transfer cases attached.
Jack must be in fully lowered positon to move load.
Always secure transmission in place with safety chain.
Use only with heavy frame service jack with removable saddle.
(See example on back page) Read, understand and follow all
warnings listed in jack instruction manual.
Vehicle must be properly supported before starting repair.
Refer to vehicle owner’s manual for proper jacking proce-
dures.
This unit is designed for use only on hard level surfaces capa-
ble of sustaining the load. Use of unit on other than hard level
surfaces can result in instablility and possible loss of load.
IMPORTANT SAFETY INFORMATION
1. Visual inspection must be made before each use of this unit, checking
for cracks, cracked welds and missing and/or damaged parts. Any
unit that appears to be damaged in any way must be removed from
service immediately.
2. BECAUSE OF THE POTENTIAL HAZARDS ASSOCIATED WITH THE
MISUSE OF EQUIPMENT OF THIS TYPE, NO MODIFICATIONS
SHALL BE MADE TO THE PRODUCT.
3. Keep adaptor well lubricated at all
points shown in drawing at right.
4. Replace worn or damaged parts
with Performance Tool replace-
ment parts. Be sure that only
qualified personnel perform
repairs.
CARE & MAINTENANCE
1
14
14
15
15
16
18
16
14
14
20
15
16
17
10
19
2
11
11
13A
21
12
3
4
5
6
7
8
9
13B
Oil Oil
To Next Page
Loading...
Need help?
General