Maximum HP developed ...............3/4
Volts ....................................................115
Hertz ...................................................60
RPM ......................................................3450 (no load speed
)
GRINDING WHEEL SIZE ................8" X 1" X 5/8"
GRINDING WHEEL GRIT ...............36 & 60
LEFT & RIGHT TOOL RESTS
LEFT & RIGHT EYE SHIELDS AND ASSEMBLIES
LEFT & RIGHT SPARK GUARDS
PROTECT YOUR EYES.
The operation of any power tool can
result in foreign objects being thrown
into the eyes which can result in severe
eye damage. Always wear eye protection
during power tool operation.
SAFETY
GLASSES
PLEASE WEAR
FORESIGHT IS BETTER
THAN NO SIGHT
To avoid electrical shock to yourself and
damage to the bench grinder, use proper
circuit protection.
The Bench grinder is factory wired for 115V,
60 Hz operation. Connect to a 115V, 15 amp
branch circuit and use a 15 amp time delay
fuse or curcuit breaker. The electrical circuit
can not have any wire size less than #12. To
avoid shock or fire, replace power cord
immediately if it is damaged in any way.
SPECIFICATIONS
8" Bench Grinder
Stock Number W50058
OWNER’S MANUAL
TABLE OF CONTENTS
Safety Instructions .................................................................2
Bench Grinder Safety .............................................................3
Electrical Requirements .........................................................3
Replacement Parts List ..........................................................4
Bench Grinder Assembly .......................................................4
Maintenance ............................................................................5
Warranty ..................................................................................6
To Next Page
Need help?
General
